Water resistant (D3), fast-setting crosslink adhesive suitable for finger jointing, edge gluing, veneering and joinery applications.
Suitable for use in hot presses, radio frequency (RF) or cold press machinery.
Conforms to BS EN 204 - Exposure group D3 for water resistance.
COMMON USES
For applications requiring high heat & water resistance.
Finger jointing, lamination & post forming of high pressure laminates (HPL) to particle board & MDF, edge and face gluing, panel and frame assembly, veneering
BONDS Foam and textiles to timber, carpets, fabrics, cardboard, triflex and fibreglass plus most materials used in the manufacture of automotive interior components.
ADVANTAGES
D3 water resistance
High heat resistance
Tough resilient bonds
Can be hot pressed to speed production
PROPERTIES
Viscosity: Approx. 4,500 cps
Solids: Approx. 48 %
pH: Approx. 3.3
PREPARATION The timber surface must be clean, dry, and free from grease, oil and sanding dust. Freshly prepared timber surfaces will always give the best bond performance.
TECHNICAL DETAILS
AQUENCE KL 442.3051 is a pre-catalysed, fast setting emulsion adhesive.
APPLICATION METHOD Adhesive should be applied as a thin, even coating to one surface only. For full application details, see the Tech Data Sheet.
APPEARANCE
White liquid
Dries clear
ODOUR Little odour wet. None dry.
CLEAN UP Equipment can be cleaned up using water while still wet.
LIMITATIONS The suitability for some exotic timbers, (eg: Teak, Rubber wood) and local timber species such as Totara or Matai should be fully tested by the user.
Suitable for use in hot presses, radio frequency (RF) or cold press machinery.
Conforms to BS EN 204 - Exposure group D3 for water resistance.
COMMON USES
BONDS
Foam and textiles to timber, carpets, fabrics, cardboard, triflex and fibreglass plus most materials used in the manufacture of automotive interior components.
ADVANTAGES
The timber surface must be clean, dry, and free from grease, oil and sanding dust. Freshly prepared timber surfaces will always give the best bond performance.
TECHNICAL DETAILS
Adhesive should be applied as a thin, even coating to one surface only. For full application details, see the Tech Data Sheet.
APPEARANCE
Little odour wet. None dry.
CLEAN UP
Equipment can be cleaned up using water while still wet.
LIMITATIONS
The suitability for some exotic timbers, (eg: Teak, Rubber wood) and local timber species such as Totara or Matai should be fully tested by the user.